Power Saver Settings - Fuji Xerox ApeosPort-V C5575 Administrator's Manual

Print-On-Demand Duration
Specify the duration for the machine to receive a print job from web applications. Unless the
machine receives full data of the print job within the specified period of time, the machine
does not process the print job.
Specify the time duration between 0 and 255 minutes in 1 minute increments. If you specify
[0], it means that there is no time limit set on the machine for receiving data.
Note

Power Saver Settings

You can configure the following settings of Power Saver mode.
Power Saver Timers
The Power Saver mode has two modes: the Low Power and Sleep modes. When a specified
period of time has elapsed, the machine switches to these modes in the following order to
reduce power consumption.
Last operation on the machine  Low Power mode  Sleep mode
For more information on the setting procedure, refer to "Power Saver Mode" (P.27).
Note
 From Last Operation to Low Power Mode
Specify a time period between 1 and 240 minutes in 1 minute increments to enter the Low
Power mode after the last operation.
Note
 From Last Operation to Sleep Mode
Specify a time period between 1 to 240 minutes in 1 minute increments to enter the Sleep
mode after the last operation.
Note
Enter Power Saver after Printing Ends
Set when to enter the Power Saver mode after a print job or printing of fax/Internet fax
documents is finished.
 15 seconds after Auto Printing Ends
Enters Sleep mode in 15 seconds.
 According to Power Saver Timer Settings
Enters Low Power mode or Sleep mode according to the period specified in [Power Saver
Timers].
For more information on the setting procedure, refer to "Power Saver Mode" (P.27).
• When you send a print job that contains a large amount of data or a print job whose contents take a
while to be processed, transmission may be timed out before the machine receives the last page of
the print job. If transmission is timed out, the print job will be canceled. Therefore, you should
consider the machine usage when you set the time duration.
• You cannot configure the machine not to switch to the Low Power mode or the Sleep mode.
• The timer does not start counting until the operator leaves the detectable area of Smart
WelcomEyes. The Access Lamp lights up while the machine detects human presence.
• Configure the [From Last Operation to Sleep Mode] time to be same or longer than the [From Last
Operation to Low Power Mode] time.
• The machine enters Sleep mode without entering Low Power mode when the [From Last Operation
to Low Power Mode] time is same as the [From Last Operation to Sleep Mode] time.
• The timer does not start counting until the operator leaves the detectable area of Smart
WelcomEyes. The Access Lamp lights up while the machine detects human presence.
Common Service Settings
163
5