Fuji Xerox ApeosPort-V C5575 Administrator's Manual page 566

15 Problem Solving
Error Code
033-535 [Cause]
[Remedy] Confirm information such as the recipient and folder information, and execute the
033-536
[Cause]
033-537
[Remedy] Execute the operation again.
033-538 [Cause]
033-539
[Remedy] Execute the operation again. If the error still is not resolved, contact our Customer
033-540
033-541
[Cause]
[Remedy] Specify the recipient correctly.
033-542 [Cause]
[Remedy] Specify a connected line.
033-543 [Cause]
[Remedy] Enter a correct fax number, and execute the operation again.
033-544 [Cause]
[Remedy] Wait for a while, and then execute the operation again.
033-545
[Cause]
[Remedy] Confirm that you specified the correct number, and execute the operation again. If the
033-546 [Cause]
[Remedy] Check whether the line is connected correctly.
033-547 [Cause]
[Remedy] No measure is required.
033-548 [Cause]
[Remedy] Establish communication such as by telephone, and execute the operation again.
033-549
[Cause]
[Remedy] Wait for a while, and execute the operation again.
033-550 [Cause]
[Remedy] Wait until the job being communicated completes, and then execute the operation
033-551
[Cause]
[Remedy] Wait for a while, and execute the operation again.
15
033-552 [Cause]
[Remedy] Confirm the model of the other machine, and execute the operation again. If receiving,
033-553 [Cause]
[Remedy] If necessary, check whether the sender entered an invalid F-code.
033-554
[Cause]
[Remedy] No measure is required.
566
Cause and Remedy
An error occurred during fax transmission.
operation again.
An error occurred during fax transmission.
An error occurred during fax transmission.
Support Center.
The recipient is not specified.
A line was specified that is not connected.
The recipient (fax number) is incorrect.
The recipient's line is busy.
There was no response from the fax recipient.
same message is displayed again, the recipient may not support fax, or the recipient
machine may be powered off. Ask the recipient for details.
A dial tone was not detected.
Communication was terminated by a cause such as pressing the <Stop> button.
Cannot transmit manually because a line is unavailable.
Cannot use the Fax service because of causes such as memory is insufficient.
Cannot execute another job because fax communication is in progress.
again.
You attempted to change a job immediately before fax or telephone communication
completed.
The total quantity of error lines detected with G3 exceeded the set value.
ask the sender to send again.
This machine does not have confidential or relay function. The F-code sent from the
other machine contains an instruction for a function not supported by the machine.
The password was omitted or did not match in fax communication.