16 Appendix
6
Enter the value you measured in step 5 in
[Values A & B Before Adjustment], and the
value to which to adjust in [Desired Values A &
B].
Important • Set value B so that an edge of the paper does
7
Select [Adjust].
8
Select [Sample Printout] again.
9
Select the tray in which you loaded paper, and press the <Start> button.
The sample is printed.
10
Select [Close].
11
Confirm the result of sample printout.
12
Adjust the alignment again if necessary. (Step 5 to 11)
13
Select [Save].
14
Select [Close] until the Services Home screen is displayed.
Note
16
666
not extend beyond a fold position of the
paper. Extending an edge of paper beyond a
fold position of the paper may cause a paper
jam.
• When you configure settings under [System Settings] or [Setup] and then press the <Services Home>
button, the screen directly goes back to the Services Home screen.