Changing Settings During Printing; Feed Adjustment - Epson SC-F7100 Series User Manual

SC-F7200 Series/SC-F7100 Series/SC-F7000 Series User's Guide
H
Use the d/u buttons to select a test pattern and
press the Z button twice.
The longer the pattern, the more accurate the
adjustment.
I
The printer will print a test pattern.
When printing is complete, the media will
automatically be fed to a position where the
pattern is clearly visible.
J
Measure the distance between the "+" symbols.
Use values measured at #1 and #2.
K
Pattern length is displayed in the control panel.
Select the values measured in Step 10.
Use the l/r buttons to select the number of #1
and press the Z button. Use the l/r buttons to
select the number of #2 and press the Z button.
L
If configuration is finished, the printer returns to
a ready state.
Basic Operations
Changing Settings During
Printing
Feed Adjustment and Heating & Drying can be changed
during printing using the procedures shown below.
Heating & Drying is only available for the SC-F7200 and
SC-F7100 Series.

Feed Adjustment

Buttons that are used in the following settings
A
Press the
B
An adjustment value will be displayed. Use the
d/u buttons to select a value.
If the feed amount is too small, black bands (dark
stripes) will appear; adjust the feed amount
upwards.
If, in contrast, the feed amount is too large, white
bands (pale stripes) will appear; adjust the feed
amount downwards.
C
If you are not satisfied with the results, use the
d/u buttons to enter an adjustment value.
D
Press the Z button when settings are complete.
70
button during printing.