Epson SC-F7100 Series User Manual page 144

SC-F7200 Series/SC-F7100 Series/SC-F7000 Series User's Guide
Auto Take-up Reel Unit
A
Use the large hexagon wrench to loosen the four
fixing screws on the front of the printer as shown
in the illustration.
B
Loosen the roll core holder locking screws and
move the left roll core holders to the outside.
Next, tighten the roll core holder locking screw to
align the right roll core holder with the position
of dotted line.
Appendix
c
Important:
If the left roll core handle shaft is not visible,
rotate the handle as shown in the illustration
below until it stops.
C
Insert the roll core into the right roll holder. Next,
insert the left roll core holder into the roll core,
and then tighten the roll core holder locking
screw.
144