Head Alignment; Heating & Drying *1 - Epson SC-F7100 Series User Manual

SC-F7200 Series/SC-F7100 Series/SC-F7000 Series User's Guide

Head Alignment

Select Head Alignment to realign the print head when
print results seem grainy or out of focus.
For Head Alignment, you need to check the pattern and
enter the optimum adjustment value for alignment.
See the following for details
"Correcting Print Misalignment (Head
U
Alignment)" on page 67
Heating & Drying(SC-F7200/
SC-F7100 Series only)
Set the temperature of the after heater or Drying Time
Per Pass.
Note:
Adjust Heater Temperature as follows:
❏ Set the heater to the temperatures recommended in
the documentation provided with the media, if
available.
❏ Raise the temperature if the print results are blurred
or smudged or the ink clots. Note, however, that
raising the temperature too high can cause the
media to shrink, wrinkle, or deteriorate.
A
Use the d/u buttons to select Heating & Drying
and press the Z button.
B
Use the d/u buttons to select the item you want
to change.
Heater Temperature
(1) Select Heater Temperature and press the Z
button.
(2) Use the d/u buttons to set the after heater
temperature.
Drying Time Per Pass
(1) Use the d/u buttons to select Drying Time Per
Pass and press the Z button.
Basic Operations
(2) Use the d/u buttons to set the drying time.
When you want to maintain a constant drying
time even when the print width changes, set the
following value in accordance with the media
width.
Drying Time Guidelines by Media Width
Media width
Blank Area Feed
(1) Use the d/u buttons to select Blank Area Feed
and press the Z button.
(2) Use the d/u buttons to select the desired setting.
The following section shows the recommended
setting values for Blank Area Feed according to
the Number of passes.
Recommended setting values for Blank Area
Feed
Number of
passes
After Heater Feed
(1) Use the d/u buttons to select After Heater Feed
and press the Z button.
(2) Use the d/u buttons to select whether to feed
media to the after heater after printing (On/Off).
C
After finishing the configuration, press the Z
button.
63
Drying time (seconds)
162.56 cm
132.08 cm
111.76 cm
106.68 cm
91.44 cm
60.96 cm
Blank Area Feed
1 Mode 1
2 to 4 Mode 2
6 to 8 Mode 3
2.3
2.0
1.8
1.7
1.6
1.3