Take-Up Tension; Media Tension; Feed Speed - Epson SC-F7100 Series User Manual

SC-F7200 Series/SC-F7100 Series/SC-F7000 Series User's Guide
Take-up Tension (SC-F7200/
SC-F7100 Series only)
Take-up Tension has 2 settings: Auto and Manual.
The default setting of Auto is recommended in most
situations. If media wrinkles when printing, or white
banding (white or light lines) appears in the print
results, we recommend using Manual and setting the
value to lower than Lv3. Make the same settings if ink
adheres to the back of the take-up roll. If thick media
cannot be wound correctly, we recommend using
Manual and setting the value to higher than Lv3.
If you have previously performed Feed Adjustment, you
will need to perform it again after adjusting Take-up
Tension.
"Feed Adjustment" on page 62
U
A
Use the d/u buttons to select Take-up Tension
and press the Z button.
B
Use the d/u buttons to select the item you want
to change.
Selecting Auto
(1) Select Auto and press the Z button.
(2) Confirm that the checkbox has been selected
and press the Z button.
(3) Press the y button to return to the customize
settings menu.
Selecting Manual
(1) Select Manual and press the Z button.
(2) Use the d/u buttons to set the recommended
value.
(3) After finishing the configuration, press the Z
button.
(4) Press the y button twice to return to the
customize settings menu.
Media Tension (SC-F7000 Series only)
We recommend setting Media Tension to the value
below that complies the width of the loaded media. The
value depends on the Tension Measurement setting.
Basic Operations
A: Value of Media Tension (when Tension
Measurement is Periodically/Every Page)
B: Value of Media Tension (when Tension
Measurement is Off)
Recommended values for Media Tension by media
width
64
A Lv28
B Lv39
If you have previously performed Feed Adjustment, you
will need to perform it again after adjusting Media
Tension.
"Feed Adjustment" on page 62
U
A
Use the d/u buttons to select Media Tension
and press the Z button.
B
Use the d/u buttons to choose a value.
C
After finishing the configuration, press the Z
button.
D
Press the y button to return to the customize
settings menu.

Feed Speed

Auto is displayed for the SC-F7200 and SC-F7100 Series
only. The default setting for the SC-F7200 and
SC-F7100 Series is Auto. The default setting for the
SC-F7000 Series is Lv2. The manufacturer default set
value is recommended in most circumstances. Set Lv1 if
thin media is creased or torn or sticks together or
horizontal lines appear during printing. To increase the
printing speed, set Lv2. Note that the speed does not
change when a large number (of passes) was selected.
A
Use the d/u buttons to select Feed Speed and
press the Z button.
B
Use the d/u buttons to select the desired setting
and press the Z button.
C
After finishing the configuration, press the Z
button.
66
52 44 42 36
Lv23 Lv19 Lv19 Lv16
Lv32 Lv27 Lv26 Lv22
24
Lv11
Lv15