Epson SC-F7100 Series User Manual page 159

SC-F7200 Series/SC-F7100 Series/SC-F7000 Series User's Guide
Q
While checking the state of the two lines, use the
hexagon wrench (large) to adjust the screw so
that the drawn line aligns with the position of the
dotted line.
While pressing on the media guide bar with your
hand, align the lines by rotating the adjustment
screw. If the drawn line is below the white line,
rotate the adjustment screw counterclockwise. If
the drawn line is above the white line, rotate the
adjustment screw clockwise. One turn of the
screw moves the line about 1 mm.
R
Use the small hexagon wrench to tighten the 2
screws.
Appendix
S
Pull out the adjustment paper from the printer,
loosen the left roll core holder locking screw, and
remove the roll core holder.
T
Remove the roll core.
When using the SC-F7000 Series
A
Raise the tensioner up and set it near legs for this
procedure.
B
Use a hexagon wrench to loosen the 4 screws.
159