Table of Contents
Advertisement
SC-F7200 Series/SC-F7100 Series/SC-F7000 Series User's Guide
Replacing and Refilling Consumables
When to perform
When an ink low warning is displayed on
the control panel display, and the amount
of ink remaining is less than 70 mm
When a prepare and replacement
message is displayed on the control panel
display
❏
If the printout is faint or smudged, or
segments are missing even after
cleaning
❏
When ink adheres to the absorber on
the back of the wiper cleaner
❏
When wipers are worn or
deteriorated
When the plates are deformed or
damaged.
Other Maintenance
When to perform
Once a week
❏
When checking if nozzles are clogged
❏
When checking which colors are
clogged
❏
Horizontal stripes or tint unevenness
(banding) are appeared.
When a clog is found after checking for
clogged nozzles
Maintenance
When to replace or refill
Chip unit and ink pack
"Chip Unit Replacement and Ink Refills" on page 85
U
Waste Ink Bottle
"Disposing of Waste Ink" on page 91
U
❏
Wiper cleaner, wiper
Be sure to replace the wiper cleaner and the wiper at the same time.
"Replacing the Wiper Cleaners and Wipers" on page 93
U
Media holding plate
"Replacing the Sliding Media Holding Plates" on page 95
U
Type
Stirring High Density Black ink
"Stirring High Density Black ink" on page 98
U
Print a check pattern and check which color nozzles are missing.
"Checking for Clogged Nozzles" on page 99
U
If no nozzles are clogged, see "Problem Solver" and "Horizontal stripes or tint
unevenness (banding)" for other solutions.
U
"Head Cleaning" on page 100
U
75
Advertisement
Table of Contents
