Table of Contents
Advertisement
SC-F9300 Series
User's Guide
Head Alignment
Depending on the model or setting status being used,
the maximum length of the media required to print the
test pattern differs as shown below.
Status
In 1 head mode
In 2 head mode
Setting procedure
A
Check that the printer is ready, and load the
media according to the actual usage conditions.
When using the Auto Take-up Reel Unit, attach
the media to the roll core.
"Loading media" on page 27
U
"Using the Auto Take-up Reel Unit" on
U
page 33
B
Press the Menu button.
The settings menu will be displayed.
C
Select Media Setup - Customize Settings -
Media Adjust - Manual - Head Alignment.
D
Press the Z button to print the adjustment
pattern.
Wait until printing is complete.
E
Check the printed adjustment pattern.
Status
In 1 head mode
In 2 head mode
Basic Operations
Length of Media
Used
Approx. 270 mm
Approx. 320 mm
F
G
The media setup menu will be displayed when you enter
the pattern number for the last color.
Changing settings during
printing
Adjustment
Changing the Heater's
Pattern
Temperature
4 blocks, A to D
Buttons that are used in the following settings
12 blocks, A to L
A
50
Select the finest lined pattern (all lines overlap)
for both. Select "-1" in the cases shown below.
The screen for entering values is displayed.
Using the u/d buttons, enter the pattern number
recorded in Step 5 and press the Z button.
When multiple check patterns have been
printed, select the number per check pattern, and
then press the Z button.
Press the
button during printing.
The Heating & Drying menu is displayed.
Advertisement
Table of Contents
