Epson SC-F7100 Series User Manual page 148

SC-F7200 Series/SC-F7100 Series/SC-F7000 Series User's Guide
R
While checking the scale of film a on the front
side of the printer, make adjustments using the
large hexagon wrench while you use your hand to
hold the media guide bar.
If the adjustment screw is turned
counterclockwise, the scale moves back. If the
adjustment screw is turned clockwise, the scale
moves towards you. One turn of the screw moves
the line about 1 mm. If the value of this scale
matches the left side, the adjustment is complete.
S
Use the small hexagon wrench to tighten the 2
screws.
Appendix
T
At the rear of the printer, remove the
counterweight attached to film a.
U
Pull out film a from the printer. Next, loosen the
right roll core holder locking screw and remove
the roll core holder from the roll.
V
Remove the roll core.
148