Table of Contents
Advertisement
• All Nozzles: Select this option when you see faint printing or gaps in all rows of nozzles in the
check pattern. Go to step 5.
4. On the LCD screen, select the nozzle rows for cleaning and then select OK.
A confirmation message appears.
5. Select Start.
Head cleaning starts. When it is complete, a confirmation message appears.
6. Select Yes to print a nozzle check pattern to confirm that the nozzles are cleared.
If clogging is cleared, you are done. If some nozzles are still clogged, return to step 1 and run
Cleaning (Light). If nozzles are still clogged, run the next higher level of cleaning. If nozzles are still
clogged after cleaning the print head several times, the edges around the print head may be soiled.
Clean around the print head.
Parent topic:
Related tasks
Performing a Nozzle Check
Cleaning the Suction Cap
Cleaning Around the Print Head
Print Head Alignment
A gap between the print head and the T-shirt may cause ink misalignment that produces grainy or blurry
printouts. This occurs due to the environmental temperature and humidity, inertial force of the print head
movements, direction of the print head movement, and thickness and texture of the media. Ink
misalignment can also occur if the platen feed varies for some reason.
To correct this problem, perform the following procedures from the printer's control panel as necessary:
Note: Before performing any adjustments, make sure the nozzles are not clogged and clean the print
head, if necessary.
• Standard (when printouts contain vertical lines or faint text)
• Micro Adjust (to fine-tune adjustments after head alignment)
Note: If you are using the medium grooved platen or the sleeve platen, or when the print surface of the
media is not flat, perform Micro Adjust before a Standard adjustment.
Aligning the Print Head
Print Head Maintenance
111
Advertisement
Table of Contents
