Printing Density; Output Priority; Output Tray; Scanner Dry - Minolta Di200f Operator's Manual

4/6

Printing Density

Select the print exposure level from among "-2," "-
1," "0," "1," or "2."
The initial setting is "0."

Output Priority

Select the default combination of the finishing
type when the machine is equipped with a Finisher
or Mailbin Finisher from among the following:
Non-Sort, Sort, Group,
Hole Punch (Only when Finisher FN-504 is
mounted.)
2-Hole Punch (Only when Finisher FN-109 is
mounted.)
3-Hole Punch (Only when Finisher FN-109 is
mounted.)
Corner Staple
2-Point Staple
(Only when Finisher FN-109 is mounted.)
The initial setting is "Non-Sort."
1. Making the User's Choice Settings
5/6
Intelligent Sorting
Select whether to turn "ON" or "OFF" the
function that automatically switches between Sort
and Non-Sort, selecting Non-Sort if only a single
original is loaded and Sort if two or more originals
are loaded in the document feeder.
The initial setting is "ON."

Output Tray

Select either "1(st bin)," "2(nd bin)," or "3(rd
bin)" for output when the machine is equipped
with a Job Tray, Finisher, or Mailbin Finisher.
The initial setting is
When a Job Tray is mounted
PC prints: 1
Copies: 2
When a Finisher is mounted
PC prints: 2 (Elevator Tray)
When a Mailbin Finisher is mounted
PC prints: 2 (Elevator Tray)
* The "3(rd bin)" option becomes available only
when an Option Tray is mounted.
"Small" Originals
Select whether to enable ("ON") a copy cycle or
not ("OFF") when it is initiated by pressing the
Start key with no originals placed on the Original
Glass or with an original smaller than the
detectable size placed on the glass in the Auto
Paper mode.
If this function is turned "ON," the copy cycle will
run using the paper loaded in the default paper
source. If turned "OFF," a warning message
appears to instruct the user to select the paper.
The initial setting is "ON."

Scanner Dry

Set the time for automatically dehumidifying the
Scanner. Any value up to 24 hours may be set in 1
min. increments.
8-5