Loading The Originals In Document Feeder - Minolta Di200f Operator's Manual

Loading the Originals in Document Feeder

Automatic Document Feeder
1
Slide the Document Guide Plate to the size of
the originals.
Useful Tip
Slide the Feed Tray Extender and Document
Stopper out when loading originals of a size
larger than Letter.
2
Neatly load stack of originals face up on the
Document Feed Tray.
NOTES
• The maximum number of originals that can be
loaded is 70.
• Make sure that the top level of the original
stack does not exceed the ▼ marking.
• Make sure that the Document Guide Plate is
touching the edges of the original stack. If it's
not pressed snugly against the original stack,
skewed feeding could result.
• You can make copies automatically from
originals of assorted sizes loaded in the
Automatic Document Feeder. ☞p.2-32
NOTES
• When loading the original in the Automatic
Document Feeder, load it in the direction as
shown in the illustration.
Feed Tray Extender
Document Stopper
4015O043AA
4015O044AB
• If you need to load your original in a direction
different from these examples, set "Original
Direction" on the Touch Panel. ☞p.3-35
• To send a facsimile, load the original in the
Automatic Document Feeder so that its longer
side is placed against the Document Guide
Plate. If the original is loaded with its shorter
side against the Document Guide Plate, the
receiving party may receive it in a reduced size.
3
Press the Start key. The originals will be fed
into the Automatic Document Feeder,
starting with the top page.
NOTES
• The machine can send by facsimile the image of
the original of a nonstandard size as long as it
falls within the following sizes.
Maximum
• The machine may fail to read the areas of 1/2
inch margins on top, bottom, right, and left
edges of the original if it is to be sent by
facsimile.
2-27
5. Placing the Original
4015O045AB
4015O046AB
Minimum
4015O266EA
4015O267EA