Settings For Initial Settings; Initial Settings - Minolta Di200f Operator's Manual

9-18

5. Settings for Initial Settings

Initial Settings

The initial or default settings, which are automatically selected when power is turned ON or the Panel
Reset key is pressed, are set. This function allows the ID, line, functions, control, and other information
that relates to your fax machine to be programmed or modified.
ID
TSI
The TSI information can be programmed when
you notify your name to the destination. Up to 40
characters can be used to specify your name as
TSI. A maximum of the first 20 characters of your
name are printed if the Access Mode key is
pressed and your account is identified with the
specific access code to transmit a document.
The TSI is printed on the leading edge on the
received document. It is also possible to select not
to print the TSI information. ☞p.9-28
Self-ID
If your name and fax number are programmed as
the ID in advance, that ID is printed on the
management report or displayed on the Touch
Panel of the fax machine on the receiving end, so
the recipient will know who sent the document. Up
to 12 characters can be used for an ID.
* The fax machine on the receiving end may not be
able to display Self-ID, depending on the model.
In this case, Self-Telephone Number will be
displayed.
Self-Telephone #1, 2
Your telephone (fax) number can be programmed.
It is notified to the destination.
Numerals of up to 20 digits can be entered as the
Self-Telephone number.
The Self-Telephone number may be printed on
reports at the destination. It is therefore
recommended that the area code be included in it
for easier recognition on the part of the recipient.
* "Self-Telephone #" is displayed only if the
optional G3 MULTIPORT SERIES 2 in not
mounted.
Line
Line Type (1), (2)
There are two types of telephone line - touch-tone
lines (PB) and dial phone lines (DP10, DP20).
Transmission will be impossible unless your
telephone line type and the setting for this machine
are compatible. Set Line Type to be used for the
machine after checking the telephone line type
being used.
The factory setting is "PB."
* "Line Type" is displayed only if the optional G3
MULTIPORT SERIES 2 is not mounted.
PSTN/Ext Switch 1, 2
Setting can be made for use of this machine over
an ordinary subscriber line connected via a PBX
(private branch exchange).
However, if a PBX is connected, this machine may
not perform correctly for fax transmission.
The factory setting is "PSTN."
* "PSTN/Ext Switch" is displayed only if the
optional G3 MULTIPORT SERIES 2 is not
mounted.