Table of Contents
Advertisement
240@120PPS> in NTSC (<720×576@25PPS>, <720×288@50PPS>,
<360× 288@SeriesPPS>in PAL).
Move the cursor to this item and press ENTER, then select a Record
mode using UP / DOWN buttons.
message
"This will FORMAT ALL HARDDISKS and LOAD THE FACTORY
DEFAULT CONFIG!" will be shown on the screen. Press ENTER to confirm the
selection, then the unit starts to format the hard disks and load the factory default
settings, or press ESC to abort. We strongly recommend to backup your
programmed configuration before making any changes on Record Mode settings.
5.4.2 Schedule Setup
This submenu is used to set the day and night time, or weekend recording
schedule.
The Night and Day schedules are used to define daytime and nighttime;
the Weekend schedule is tailored for weekends and holidays.
Select <Schedule Setup> from the Record Setup menu and press
ENTER; the following menu is displayed.
1.
1. Day Time Start 06:00
2.
2. Night Time Start 18:00
3.
3. Weekend Schedule YES
4.
4. Weekend Start Fri 18:00
5.
5. Weekend End Mon 06:00
5.4.2.1 Day / Night Time Start
The Day/Night Start Time determines the beginning of day/night recording
time. Time is indicated in 1-minute increments. The time display format in
this
NOTE: After changing the Record Mode setting, the warning
Schedule Setup
menu
is
based
on
the
setting
of
Time
Display
Mode.
Advertisement
Table of Contents
