Termination; Brightness; Contrast; Saturation - IDVIEW PIV Series User Manual

unit is continuing recording video. Choosing <YES> means to cover the
selected camera; and <NO> to remain the selected camera non-covert.
The default setting is <NO>.
To make a camera be covert, follow these steps:
. • Select the channel that you want it to be covert from the <Channel Select>
item.
. • After selecting the channel, move the cursor to <Covert> item and select
<YES>.

5.3.6 Termination

This item is used to enable / disable the 75-termination resistor inside the
unit to adjust the image quality of each camera. <YES>= termination
resistor enabled (default), <NO> = termination resistor disabled.
termination resistor should be enabled for appropriate signal termination.

5.3.7 Brightness

Move the cursor to the item and press ENTER for adjusting the brightness
of the camera. Use UP / DOWN buttons to adjust the numeric value. The
range of brightness values is <-128> to <127>. The default setting is <0>.

5.3.8 Contrast

Move the cursor to the item and press ENTER for adjusting the contrast of
the

5.3.9 Saturation

Move the cursor to the item and press ENTER to adjust the color
saturation of the camera using UP / DOWN buttons. This value will be
ignored on monochrome monitors. The range of saturation values is <-
NOTE: If the camera loop-out connectors have not been used, the
camera. Use UP / DOWN buttons to adjust the value.