Table of Contents
Advertisement
3 NTSC (3
256Kbps DSL
PAL)
3 NTSC (3
128Kbps DSL
PAL)
5.4.4 ezRecord Setup
This item aims to avoid the complicated record settings, and to make the
setup much easier. Note that the item can be reached only when you
select <ezRecord> as the option for <Preset Config>.
Select <ezRecord Setup> from <Record Setup> and press ENTER, the
sub-menu appears as below figure:
ezRecord Setup How Many Days To Record 2 Days Daytime Record Yes Night Record Yes
Weekend Record YesThe Quality will Be
To have the ezRecord Setup done, follow these steps:
.
•
Select <How Many Days To Record> and press ENTER, then press
UP/DOWN to choose the option you want. The maximum of days depends of the size of
your HDD, in the other words, the larger the HDD installed, the more days the unit can
record.
.
•
Move to <Daytime Record> and press ENTER. This item is for you to
select whether you want the DVR to record during daytime. If yes, using UP/DOWN to
select <Yes> as option; or, select <No> for not recording during daytime.
.
•
Repeat the same procedures through the 3rd and 4th item, respectively.
Note that <Weekend Record> will be not accessible if you select <NO> for the item
<Weekend Schedule> in <Schedule Setup>.
.
•
According to upper item you have set, the quality will be automatically
accounted and shown on the screen. This item is for read-only. Five options, including
<Best>, <High>, <Mid>, <Fair> and <Low>, you may see on this item. We strongly
recommend to keep the quality higher than "Middle".
NOTE: The current number of connected cameras will affect the recording quality
automatically calculated through the <ezRecord Setup>. Therefore, once you
disconnect cameras or connect more cameras to the unit, you should reset the
<ezRecord Setup>.
3 NTSC (3
2 KB
PAL)
3 NTSC (3
1 KB
PAL)
Fair
2 KB
Both
1 KB
Both
Advertisement
Table of Contents
