Dhcp; Netmask; Gateway - IDVIEW PIV Series User Manual

The network related settings in the LAN Setup menu should be associated
with the network service type.
Select <LAN Setup> in Network Setup menu and press ENTER for setting
the parameters; the menu displays as follows.
1. 1. DHCP ON
2. 2. IP xxx.xxx.xxx.xxx
3. 3. Netmask xxx.xxx.xxx.xxx
4. 4. Gateway xxx.xxx.xxx.xxx
5. 5. DNS xxx.xxx.xxx.xxx
6. 6. Connect At Booting YES
7. 7. Network Restart NO

-DHCP

This item allows user to obtain a dynamic IP address from DHCP
(Dynamic Host Configuration Protocol) server during the unit boots up.
When using DHCP, the settings are dynamic and they will change every
time you power up and power off the unit; depending on your network's
setup.
If the item is enabled (ON), a dynamic IP will be assigned to PIV
MPEG-4 DVR. In this case, user does not need to configure a static IP
and the Ethernet settings including IP address, Netmask, Gateway, and
DNS settings will be read-only. The default setting is <ON>.
If you are using permanent addressing, set DHCP to <OFF> for setting the
IP Address, Netmask, Gateway, and DNS. See your network system
administrators or IT personnel for appropriate values for these settings.
-IP
The item is used to configure the IP (Internet Protocol) address of the unit.
The IP address is the identifier for your computer or device on a TCP/IP
LAN or WAN. Please note that to set a static IP address, DHCP must be
set to <OFF>.
LAN Setup
TM
Series