Rs485 Setup; Dome Controlling Button - IDVIEW PIV Series User Manual

associated with dome camera using the Direction buttons and ENTER. The available
protocol includes <IDView>, <Pelco D>, <Pelco P>, <AD422> and <None> (default).
NOTE: The settings become effective after saving the changes and exiting from
the menu.

4.5.3 RS485 Setup

TM
PIV
protocol. The RS-485 parameters in PIV
set to the same parameters as the protocol for RS-422 setup of the dome.
Users are allowed to change the RS-485 settings of the PIV
MPEG-4 DVR. Select <System Setup> in Main menu, then select <RS485
Setup> from the System Setup menu and press ENTER. The following
menu is displayed.
RS485 Setup 1 Unit ID 224 2 Baud Rate
The ID number must match the ID address set by the dome. The Unit ID is in the range
of 1 to 255. The default ID is 224. Note that no two devices on the same bus should be
given the same ID address, or a conflict may occur.
TM
The default PIV Series MPEG-4 DVR RS-485 settings are 9600 Baud, 8 Data Bits, 1
Stop Bit and No Parity.
NOTE: The settings become effective after saving the changes and
exiting from the menu.

4.5.4 Dome Controlling Button

The function buttons used in Dome Control are described as follows.
Series MPEG-4 DVR controls the domes via RS-485 communication
TM
Series MPEG-4 DVR must be
9600 3 Bits 8 4 Stop 1 5 Parity None
TM
Series