Cisco SPA232D Administration Manual page 88

Configuring the Voice Settings
Regional
Cisco SPA232D Administration Guide
Field
Ring4 Name
Ring5 Name
Ring6 Name
Ring7 Name
Ring8 Name
Ring and Call Waiting Tone Spec
IMPORTANT: Ring and Call Waiting tones do not work the same way on all
phones. When setting ring tones, consider the following recommendations:
• Begin with the default Ring Waveform, Ring Frequency, and Ring Voltage.
• If your ring cadence doesn't sound right, or your phone doesn't ring, change
the following settings:
- Ring Waveform: Sinusoid
- Ring Frequency: 25
- Ring Voltage: 80Vc
Field
Ring Waveform
Ring Frequency
Description
Name in an INVITE's Alert-Info Header to pick distinctive
ring/CWT 4 for the inbound call.
Default setting: Bellcore-r4
Name in an INVITE's Alert-Info Header to pick distinctive
ring/CWT 5 for the inbound call.
Default setting: Bellcore-r5
Name in an INVITE's Alert-Info Header to pick distinctive
ring/CWT 6 for the inbound call.
Default setting: Bellcore-r6
Name in an INVITE's Alert-Info Header to pick distinctive
ring/CWT 7 for the inbound call.
Default setting: Bellcore-r7
Name in an INVITE's Alert-Info Header to pick distinctive
ring/CWT 8 for the inbound call.
Default setting: Bellcore-r8
Description
Waveform for the ringing signal. Choices are Sinusoid or
Trapezoid.
Default setting: Sinusoid
Frequency of the ringing signal. Valid values are 10–100
(Hz)
Default setting: 20
4
87