Cisco SPA232D Administration Manual page 139

Configuring the Voice Settings
PSTN (LINE Port)
Cisco SPA232D Administration Guide
Field
VoIP Caller ID
Pattern
VoIP Access List
VoIP Caller 1/2/3/
4/5/6/7/8 PIN
VoIP Caller 1/2/3/
4/5/6/7/8 DP
Description
A comma-separated list of caller phone number patterns
that is used to allow or block access to the PSTN gateway
based on the caller ID. If the caller ID does not match a
specified pattern, access is rejected, regardless of the
authentication method. This comparison is applied before
the access list is applied. If this parameter is blank (not
specified), all callers are considered for VoIP service.
• Use ? to match any single digit.
• Use * to match any number of digits.
Example: 1408*, 1512???1234
In the above example, the caller ID either must start with
1408 or must be an 11-digit numbering starting with 1512
and ending with 1234.
Default setting: blank
A comma-separated list of number patterns that is used to
allow or block access to the PSTN gateway based on the
source IP address. If the IP address matches a specified
pattern, service is allowed without further authentication.
Example: 192. 1 68.*.*, 66.43. 1 2. 1 ??.
In the above example, the source IP address either must
begin with 192. 1 68 or must be in the range of
66.43. 1 2. 1 00-199.
Default setting: blank
A PIN number that a VoIP caller can use to access the
PSTN gateway, when the VoIP Caller Auth Method is set to
PIN.
Default setting: blank
The index number of the dial plan to use upon successful
entry of the corresponding VoIP Caller PIN. Dial plans are
configured in the Dial Plans
Default setting: 1
section.
4
138