Cisco SPA232D Administration Manual page 192

Administration Settings
Logging
NOTE
Cisco SPA232D Administration Guide
E-Mail
When logging is enabled, you can send logs to an email address by using SMTP.
Service providers' requirements vary. Be aware that some providers do not allow
SMTP email from a free account. Other providers may require a user to log on to a
new mailbox before sending emails. For accurate information, read the support
documentation from your provider. In your provider's support or help system,
search for information about SMTP server settings.
Field
Sender
Receiver
SMTP Server
SMTP Port
Subject
Number of Logs
Interval
Username
Password
Description
If you wish to send log entries to an email account,
complete all of the fields in this section. Enter a valid
email address to identify the sender of the email.
Example: user1@company.com
Enter a valid email address where the email will be sent.
Example: user2@company.com
Enter the IP address or domain name of the mail server
that you will use to send this email. Example:
smtp.gmail.com
Enter the port to use on the SMTP server. The default
value is 25. Use the port specified by your email server
administrator or service provider.
Enter a brief description for the subject line of the email.
Example: Log from My ATA
Enter the number of log entries to include in the email.
The valid range is 10 to 200.
Enter the interval, in minutes, at which to send emails.
The valid range is 1 to 1440 (24 hours).
Enter the username for the email account that will be
used to send these emails. Use the format required by
your service provider. Usually it is the full email address.
Example: user1@company.com.
Enter the password for the email account that will be
used to send these emails.
5
191