Cisco SPA232D Administration Manual page 138

Configuring the Voice Settings
PSTN (LINE Port)
Cisco SPA232D Administration Guide
VoIP-To-PSTN Gateway Setup
Field
VoIP-To-PSTN
Gateway Enable
VoIP Caller Auth
Method
VoIP PIN Max
Retry
One Stage Dialing
Line 1 VoIP Caller
DP
VoIP Caller Default
DP
Line 1 Fallback DP
Description
Choose yes to enable or choose no to disable the VoIP-To-
PSTN Gateway functionality.
Default setting: yes
The method to authenticate a VoIP Caller to access the
PSTN gateway. Choose from none, PIN, or HTTP Digest.
Default setting: none
The number of times that a VoIP caller can attempt to
enter a PIN, if the VoIP Caller Auth Method is set to PIN.
Default setting: 3
Choose yes to enable or choose no to disable one-stage
dialing. This setting applies if the VoIP Caller Auth Method
is none or HTTP Digest, or if caller is in the Access List.
Default setting: yes
The index number of the dial plan to use when the VoIP
Caller is calling from Line 1 of the same ATA during normal
operation (in other words, not due to fallback to PSTN
service when Line 1 VoIP service is down). the
Authentication is skipped for Line 1 VoIP caller.
Default setting: 1
The index number of the dial plan to use when the VoIP
Caller is not authenticated. Dial plans are configured in the
Dial Plans section.
Default setting: 1
The index number of the dial plan to use when the VoIP
Caller is calling from Line 1 of the same ATA due to
fallback to PSTN service when Line 1 VoIP service is
down.
Default setting: none
4
137