Cisco SPA232D Administration Manual page 172

Configuring the Voice Settings
DECT Line 1 - DECT Line 10
Cisco SPA232D Administration Guide
Field
PSTN Fallback Dial
Plan
Enable IP Dialing
Emergency
Number
Incoming Handset
List
Call Forward Settings
Field
Cfwd All Dest
Cfwd Busy Dest
Cfwd No Ans Dest
Description
The dial plan used when PSTN fallback is enabled and in
use.
Default setting: (S0<:@gw0>)
Enable or disable IP dialing. If IP dialing is enabled, one can
dial [userid@] a.b.c.d[:port], where '@', '.', and ':' are dialed
by entering *, user-id must be numeric (like a phone
number) and a, b, c, d must be between 0 and 255, and
port must be larger than 255. If port is not given, 5060 is
used. Port and User-Id are optional. If the user-id portion
matches a pattern in the dial plan, then it is interpreted as a
regular phone number according to the dial plan. The
INVITE message, however, is still sent to the outbound
proxy if it is enabled.
Default setting: no
Comma separated list of emergency number patterns. If
outbound call matches one of the pattern, the ATA will
disable hook flash event handling. The condition is
restored to normal after the call ends. Blank signifies that
there is no emergency number. Maximum number length is
63 characters.
Default setting: blank
The devices that ring when an incoming call is received.
Default setting: fxs,1,2,3,4,5,6,7,8,9,10
Description
Forward number for Call Forward All Service.
Default setting: blank
Forward number for Call Forward Busy Service. Same as
Cfwd All Dest.
Default setting: blank
Forward number for Call Forward No Answer Service.
Same as Cfwd All Dest.
Default setting: blank
4
171