Cisco SPA232D Administration Manual page 141

Configuring the Voice Settings
PSTN (LINE Port)
Cisco SPA232D Administration Guide
Field
PSTN Ring Thru
Line 1
PSTN PIN Max
Retry
PSTN CID for VoIP
CID
PSTN CID Number
Prefix
PSTN Caller
Default DP
Line 1 Signal Hook
Flash to PSTN
PSTN CID Name
Prefix
Description
To enable ring through to Line 1 based on caller number
patterns, choose yes. Otherwise choose no.
Note: For more information about PSTN Caller number
patterns, see PSTN Caller ID
Default setting: yes
The number of times that a PSTN caller can attempt to
enter a PIN number, if the authentication method is set to
PIN.
Default setting: 3
Choose yes or no.
Default setting: no
A dialing prefix, if needed, to add to the caller ID number
on the PBX to ensure that a callback goes to the correct
number.
Default setting: blank
The index number of the dial plan that is used when the
PSTN Caller Auth Method is set to none. Dial plans are
configured in the Dial Plans
Default settings: 1
Specify the operation of the hook flash on the analog
phone when a PSTN-to-VoIP call is active. Choose
Disabled or Double Hook Flash.
Default setting: Disabled
The prefix to add to the caller ID name that is sent to the
PBX. Enter the characters to add to the caller ID name.
Default setting: blank
Pattern.
section.
4
140