Cisco SPA232D Administration Manual page 151

Configuring the Voice Settings
User 1
Cisco SPA232D Administration Guide
Field
Dist Ring Setting
Secure Call
Setting
Message Waiting
Accept Media
Loopback Request
Description
Distinctive Ring on or off.
Default setting: yes
If yes, all outbound calls are secure calls by default,
without requiring the user to dial a star code first.
Default setting: no
• If Secure Call Setting is set to yes, all outbound
calls are secure. However, a user can disable
security for a call by dialing *19 before dialing the
target number.
• If Secure Call Setting is set to No, the user can
make a secure outbound call by dialing *18 before
dialing the target number.
• A user cannot force inbound calls to be secure or
not secure; that depends on whether the caller has
security enabled or not.
Note: This setting is applicable only if Secure Call Serv is
set to yes on the line interface. See
(PHONE Port), page
Setting this value to yes can activate stutter tone and
VMWI signal. This parameter is stored in long term
memory and will survive after reboot or power cycle.
Default setting: no
Controls how to handle incoming requests for loopback
operation.
Default setting: automatic
• never: Never accepts loopback calls; replies 486 to
the caller.
• automatic: Automatically accepts the call without
ringing.
• manual: Rings the phone first, and the call must be
picked up manually before loopback starts.
Default setting: Automatic
Line 1 Settings
100.
4
150