Cisco SPA232D Administration Manual page 84

Configuring the Voice Settings
Regional
Cisco SPA232D Administration Guide
Field
Second Dial Tone
Outside Dial Tone
Prompt Tone
Busy Tone
Reorder Tone
Off Hook Warning
Tone
Ring Back Tone
Ring Back 2 Tone
Confirm Tone
Description
Alternative to the Dial Tone when the user dials a three-
way call.
Default setting: 420@-5,520@-5;10(*/0/1+2)
Alternative to the Dial Tone. It prompts the user to enter an
external phone number, as opposed to an internal
extension. It is triggered by a comma character
encountered in the dial plan.
Default setting: 420@-4;10(*/0/1)
Prompts the user to enter a call forwarding phone number.
Default setting: 520@-5,620@-5;10(*/0/1+2)
Played when a 486 RSC is received for an outbound call.
Default setting: 480@-5,620@-5;10(.5/.5/1+2)
Played when an outbound call has failed, or after the far
end hangs up during an established call. Reorder Tone is
played automatically when Dial Tone or any of its
alternatives times out.
Default setting: 480@-5,620@-5;10(.25/.25/1+2)
Played when the caller has not properly placed the
handset on the cradle. Off Hook Warning Tone is played
when the Reorder Tone times out.
Default setting: 480@-3,620@3;10(. 1 25/. 1 25/1+2)
Played during an outbound call when the far end is ringing.
Default setting: 440@-5,480@-5;*(2/4/1+2)
Your ATA plays this ringback tone instead of Ring Back
Tone if the called party replies with a SIP 182 response
without SDP to its outbound INVITE request.
Default setting: the same as Ring Back Tone, except the
cadence is 1s on and 1s off.
Default setting: 440@-5,480@-5;*(1/1/1+2)
Brief tone to notify the user that the last input value has
been accepted.
Default setting: 600@-4;1(.25/.25/1)
4
83