Cisco SPA232D Administration Manual page 85

Configuring the Voice Settings
Regional
Cisco SPA232D Administration Guide
Field
SIT1 Tone
SIT2 Tone
SIT3 Tone
SIT4 Tone
MWI Dial Tone
Cfwd Dial Tone
Holding Tone
Conference Tone
Secure Call
Indication Tone
Description
Alternative to the Reorder Tone played when an error
occurs as a caller makes an outbound call. The RSC to
trigger this tone is configurable on the SIP screen.
Default setting: 985@-4,1428@-4,1777@-4;20(.380/0/
1,.380/0/2,.380/0/3,0/4/0)
Alternative to the Reorder Tone played when an error
occurs as a caller makes an outbound call. The RSC to
trigger this tone is configurable on the SIP screen.
Default setting: 914@-4,1371@-4,1777@-4;20(.274/0/
1,.274/0/2,.380/0/3,0/4/0)
Alternative to the Reorder Tone played when an error
occurs as a caller makes an outbound call. The RSC to
trigger this tone is configurable on the SIP screen.
Default setting: 914@-4,1371@-4,1777@-4;20(.380/0/
1,.380/0/2,.380/0/3,0/4/0)
Alternative to the Reorder Tone played when an error
occurs as a caller makes an outbound call. The RSC to
trigger this tone is configurable on the SIP screen.
Default setting: 985@-4,1371@-4,1777@-4;20(.380/0/
1,.274/0/2,.380/0/3,0/4/0)
Played instead of the Dial Tone when there are unheard
messages in the caller's mailbox.
Default setting: 350@-5,440@-5;2(. 1 /. 1 /1+2);10(*/0/1+2)
Played when all calls are forwarded.
Default setting: 350@-5,440@-5;2(.2/.2/1+2);10(*/0/1+2)
Informs the local caller that the far end has placed the call
on hold.
Default setting: 600@-5;*(. 1 /. 1 /1,. 1 /. 1 /1,. 1 /9.5/1)
Played to all parties when a three-way conference call is
in progress.
Default setting: 350@-5;20(. 1 /. 1 /1,. 1 /9.7/1)
Played when a call has been successfully switched to
secure mode. It should be played only for a short while
(less than 30 seconds) and at a reduced level (less than -
19 dBm) so it does not interfere with the conversation.
Default setting: 397@-5,507@-5;15(0/2/0,.2/. 1 /1,. 1 /2. 1 /2)
4
84