Cisco SPA232D Administration Manual page 69

Configuring the Voice Settings
SIP
Cisco SPA232D Administration Guide
Field
Reg Retry Long
Intvl
Reg Retry Random
Delay
Reg Retry Long
Random Delay
Reg Retry Intvl
Cap
Response Status Code Handling
Field
SIT1 RSC
SIT2 RSC
Description
When registration fails with a SIP response code that
does not match Retry Reg RSC, the ATA waits for the
specified length of time before retrying. If this interval is 0,
the ATA stops trying. This value should be much larger
than the Reg Retry Intvl value, which should not be 0.
Default setting: 1200
Random delay range (in seconds) to add to Register Retry
Intvl when retrying REGISTER after a failure.
Default setting: 0 (disabled)
Random delay range (in seconds) to add to Register Retry
Long Intvl when retrying REGISTER after a failure.
Default setting: 0 (disabled)
The maximum value to cap the exponential back-off retry
delay (which starts at Register Retry Intvl and doubles on
every REGISTER retry after a failure) In other words, the
retry interval is always at Register Retry Intvl seconds
after a failure. If this feature is enabled, Reg Retry Random
Delay is added on top of the exponential back-off adjusted
delay value.
Default setting: 0, which disables the exponential backoff
feature.
Description
SIP response status code for the appropriate Special
Information Tone (SIT) For example, if you set the SIT1
RSC to 404, when the user makes a call and a failure code
of 404 is returned, the SIT1 tone is played. Reorder or
Busy tone is played by default for all unsuccessful
response status code for SIT 1 RSC through SIT 4 RSC.
Default setting: blank
SIP response status code to INVITE on which to play the
SIT2 Tone.
Default setting: blank
4
68