Cisco SPA232D Administration Manual page 171

Configuring the Voice Settings
DECT Line 1 - DECT Line 10
Cisco SPA232D Administration Guide
Field
DTMF Tx Mode
Hook Flash Tx
Method
Symmetric RTP
Dial Plan
Field
Dial Plan
Description
DTMF Detection Tx Mode is available for SIP information
and AVT. Options are: Strict or Normal.
Default setting: Strict for which the following are true:
• A DTMF digit requires an extra hold time after
detection.
• The DTMF level threshold is raised to -20 dBm.
The minimum and maximum duration thresholds are:
• strict mode for AVT: 70 ms
• normal mode for AVT: 40 ms
• strict mode for SIP info: 90 ms
• normal mode for SIP info: 50 ms
Select the method for signaling hook flash events: None,
AVT, or INFO. None does not signal hook flash events. AVT
uses RFC2833 AVT (event = 16) INFO uses SIP INFO with
the single line signal=hf in the message body. The MIME
type for this message body is taken from the Hook Flash
MIME Type setting.
Default setting: None
Enable symmetric RTP operation. If enabled, the ATA
sends RTP packets to the source address and port of the
last received valid inbound RTP packet. If disabled (or
before the first RTP packet arrives) the ATA sends RTP to
the destination as indicated in the inbound SDP.
Default setting: yes
Description
The allowed number patterns for outbound calls. For
information about the dial plan syntax, see
Dial Plans, page 225.
Default setting: (*xx|[3469]11|0|00|[2-9]xxxxxx| 1 xxx[2-
9]xxxxxxS0|xxxxxxxxxxxx.)
4
Configuring
170