Cisco SPA232D Administration Manual page 82

Configuring the Voice Settings
Regional
Cisco SPA232D Administration Guide
A mini-script of up to 127 characters that specifies the cadence parameters of a
signal.
Syntax: S [;S ], where:
1 2
S =D (on ,1/off ,1[,on ,
i i i i i 2
known as a section, on
and i = 1 or 2, and j = 1 to 6. D
durations can have up to three decimal places to provide 1 ms resolution. The
wildcard character "*" represents infinite duration. The segments within a section
are played in order and repeated until the total duration is played.
Example 1: 60(2/4)
Number of Cadence Sections = 1
Cadence Section 1: Section Length = 60 s
Number of Segments = 1
Segment 1: On=2s, Off=4s
Total Ring Length = 60s
Example 2—Distinctive ring (short,short,short,long): 60(.2/.2,.2/.2,.2/.2,1/4)
Number of Cadence Sections = 1
Cadence Section 1: Section Length = 60s
Number of Segments = 4
Segment 1: On=0.2s, Off=0.2s
Segment 2: On=0.2s, Off=0.2s
Segment 3: On=0.2s, Off=0.2s
Segment 4: On=1.0s, Off=4.0s
Total Ring Length = 60s
FreqScript
A mini-script of up to 127 characters that specifics the frequency and level
parameters of a tone.
Syntax: F @L [,F @L
1 1 2 2
Where F F are frequency in Hz (unsigned integers only) and L
–
1 6
corresponding levels in dBm (with up to 1 decimal places) White spaces before
and after the comma are allowed (but not recommended)
Example 1—Call Waiting Tone: 440@-10
Number of Frequencies = 1
Frequency 1 = 440 Hz at –10 dBm
Example 2—Dial Tone: 350@-19,440@-19
Number of Frequencies = 2
Frequency 1 = 350 Hz at –19 dBm
Frequency 2 = 440 Hz at –19 dBm
ToneScript
/off , [,on /off , [,on ,
i 2 i,3 i 3 i
and off are the on/off duration in seconds of a segment
i,j i,j
is the total duration of the section in seconds. All
i
[,F @L [,F @L [,F @L
3 3 4 4 5
/off , [,on , /off , ,on
4 i 4 i 5 i 5 i
[,F @L ]]]]
5 6 6
4
, /off ]]]]]) and is
6 i,6
L are
–
1 6
81