Cisco SPA232D Administration Manual page 125

Configuring the Voice Settings
Line 1 Settings (PHONE Port)
Cisco SPA232D Administration Guide
Dial Plan Entry
xxxxxxxxxxxx.
Gateway Accounts
Field
Gateway1/2/3/4
GW1/2/3/4 NAT
Mapping Enable
GW1/2/3/4 Auth ID
GW1/2/3/4
Password
Functionality
Everything else
Description
The first of 4 gateways that can be specified to be used in
the <Dial Plan> to facilitate call routing specification (that
overrides the given proxy information). This gateway is
represented by gw1 in the <Dial Plan>. For example, the
rule 1408xxxxxxx<:@gw1> can be added to the dial plan
such that when the user dials 1408+7digits, the call will be
routed to Gateway 1. Without the <:@gw1> syntax, all calls
are routed to the given proxy by default (except IP dialing).
Default setting: blank
If enabled, the ATA uses NAT mapping when contacting
Gateway 1.
Default setting: no
This value is the authentication user-id to be used by the
ATA to authenticate itself to Gateway 1.
Default setting: blank
This value is the password to be used by the ATA to
authenticate itself to Gateway 1.
Default setting: blank
4
124