S.bus Servo - FUTABA T18SZ Instruction Manual

S.Bus servo

An S.BUS(2) servo can memorize the channel
and various settings you input. Servo setting can
be performed on the T18SZ screen by wiring the
servo as shown in the figure.
* With some S.BUS(2) servos, there are some functions with
cannot be used. If a function cannot be used, the display
screen will change. (Only the function which can be used by
a servo is displayed.)
* After reading completion, with connection of the above figure,
if a stick is moved, the test of operation of the servo can be
operated and carried out.
● Call the following setting screen by pressing the
[S.BUS Servo] button in the System menu.
●Return to System menu
Procedure for changing S.BUS servo setting
1. Select [S.Bus servo] of the System menu.
2. Wire the servo as shown in the figure above.
3. Press [Read]. The ID and current setting of
that servo are displayed.
●Servo ID number
If you use multiple S.BUS servos, only the desired
servo in the group can be set by entering the ID of
that specific servo.
S.BUS servo setting
4. When multiple servos are connected change
[INH] at the right side of the ID number on the
screen to [ACT] and enter the ID of the servo
you want to set.
5. Set each item. (Please see the next page.)
6. Press [Write]. The settings are changed.
T18SZ
＜ System menu ＞
S.BUS/S.BUS2
Servo
3-way hub
or Y-harnesses
63