V-Tail - FUTABA T18SZ Instruction Manual

V-Tail

This function let's you adjust for left and right
rudder angle changes at elevator and rudder
operation of a V-tail airplane.
V-tail is when 2 servos are used together to
control rudder movement as elevators. In addition
to each rudder side moving up and down together,
each side moves in opposite directions when moving
as elevators. On a V-tail, this is also known as a
ruddervator, as they can serve the same purpose.
● Select [V-Tail] at the model menu and call
the setup screen shown below.
●Return to Model menu
Condition group/
single mode
selection (Gr. /Sngl)
(Elevator function)
Up and down travel adjustment at
CH1 and CH2 elevator operation
[Corresponding model type]: Airplane/glider, Tail type V-tail
● Travel adjustment
Tap to the item you want to adjust .
Adjust the rate by "▼▼" "▼" "▲" "▲▲"
button.
*If the mixing direction is reversed by the linkage,
adjustments can be made by changing the mixing rate
polarity (+ or -).
*If a large value of travel is specified, when the sticks are
moved at the same time, the controls may bind or run out
of travel. Decrease the travel until no binding occurs.
＜ Model menu (Airplane/Glider/Multicopter Functions) ＞
ELEVATOR
(RUDDER 2)
(Rudder function)
Left and right travel adjustment at
CH1 and CH2 rudder operation
RUDDER
(ELEVATOR 2)
149