Acceleration - FUTABA T18SZ Instruction Manual

Acceleration

Acceleration setting can be performed at
Elevator, Ele → Camber and Ail → Rudder. (Glider
only)
● This setting is divided into elevator setting and
camber setting. The setting method is the same.
● Camber setting sets the acceleration function for
Ele to camber mixing. Setting is not performed
when Ele to camber mixing is INH.
● The acceleration function can be set for both the
up side and down side.
● Function ON/OFF switch setting is performed for
Ail→ Rudder setting only.
● Ail→ Rudder setting is acceleration
function setting for Ail→ Rudder mixing. It is not
performed when Ail→ Rudder mixing is INH.
● Select [Acceleration] at the model
menu and call the setup screen shown
below.
W h e n u s i n g t h i s
function, Tap to the
[ I N H ] i t e m . ( O N i s
displayed.)
●Return to Model menu
The rate the angle
increases.
Setting method
● Acceleration rate setting (Rate)
● The return time after operation (Damping)
can be set.
● T h e o p e r a t i o n p o i n t a t a c c e l e r a t i o n
and deceleration can be set. When an
operation point is exceeded, acceleration is
performed.
[Corresponding model type]: Glider, general
Condition group/
single mode selection
(Gr. /Sngl)
The return time after operation (Damping)
can be set.
（First return）1 ～ 100（Slow return）
（Acceleration doesn't function as 0.）
＜ Model menu (Airplane/Glider/Multicopter Functions) ＞
To next page
2/3 : Ele (Elevator) → Camber
3/3 : Ail (Aileron) → Rudder
Note: When using the acceleration funtion,
since the servo stroke is large, make your
settings so there is no binding of your linkage.
Operation up to this
range will initiate
acceleration.
Act position
Current position
147