Motor - FUTABA T18SZ Instruction Manual

Motor

This function lets you set the operation speed
when the motor of a F5B or other EP glider is
started by switch. The operation speed can be set
in 2 ranges of slow speed flight and high speed
flight (Speed 1/Speed 2). This function can also be
operated as a safety function by setting 2 switches.
● The in side and out side operating speeds can be
adjusted independently in 2 ranges (Speed 1/
Speed 2).
● The boundary between the 2 ranges can be set.
(From speed 1 to speed 2)
● Select [Motor] at the model menu and
call the setup screen shown below.
●Return to Model menu
● When using this function, tap to the [INH]
item .
● Group/single mode switching
(For more information, see the description
at the back of this manual.)
● Switch
A switch that turns the function itself
ON/OFF can be selected.
● Motor off position
Tap the motor off button when [SW-G] is in
the motor OFF position you want to set. The
direction of the motor switch is memorized.
The screen graph display OFF direction also
changes.
Notes
● First decide the motor OFF direction, and then
set the speed. When you want to reset the
motor OFF direction, also reset the speed.
● We recommend that motor OFF be set in
combination with F/S.
● Set the basic operation direction with the reverse
function to match the ESC used.
● Always set the motor OFF position.
148
＜ Model menu (Airplane/Glider/Multicopter Functions) ＞
[Corresponding model type]: Airplane/glider, general
● The set operation speed operation can be
● The motor (CH3) is controlled by SW-G. (Initial
Note: When using this function, always check initial
● When using this function, tap to the [INH]
● When you want to set the "One time mode",
● Speed 1 to 2
● Operation speed adjustment
activated at initial operation only. (1 time
operation) However, operation can be repeated
by setting the switch to OFF before operation is
finished. When you want to reset 1 time operation,
set the ACT/INH item to [INH] and then reset it to
[ON].
setting) When changing the switch or stick which
controls the motor, first change Function of the
Linkage menu.
operation with the propeller removed.
item .
tap to the [One time] item and tap the
screen.
The speed 1 and speed 2 region boundary
can be changed,
The speed when speed 1 and speed 2 are
ON (In) and OFF (Out) can be adjusted.