Calibration - FUTABA T18SZ Instruction Manual

Calibration

Usually, this calibration is unnecessary.
Please perform this calibration, only if a change
at the center of a stick should arise after prolonged
use.
●Return to System menu
How to Calibrate
1. Choose the stick to calibrate right and left.
2. The stick is set at neutral and the [Set neutral]
button is tapped.
3. The stick is held at full right and full bottom
(diagonal) the [Set endpoint] button is
tapped.
4. The stick is held at full left and full top
(diagonal) the [Set endpoint] button is
tapped.
*Please do not press the stick too firmly in any direction when
doing the calibration.
*Check after calibration to make sure that neutral is 0% and
bottom right side will be +100%, and the top left side is
become -100%.
● Tap the [Calibration] button in the System
menu to call the setup screen shown below.
Tapped
The stick is set at
neutral
Tapped
Full right and
full bottom
Tapped
Full left and
full top
＜ System menu ＞
61