Data Reset - FUTABA T18SZ Instruction Manual

Data reset

This function is designed to allow you to reset
selected portions or all of the settings saved in
the active model memory. You may individually
choose to reset the following sets of data;
T1~T6 (All condition):
Reset the digital trim setting.
*All the conditions, or the condition currently being displayed
(the entire group for group setting), can be selected.
*The trim step amount and trim rate are not reset.
T1~T6 (Current and Group condition):
Reset the digital trim setting.
*Current condition, group condition, can be selected.
*The trim step amount and trim rate are not reset.
● Select [Data reset] at the linkage menu and call
the setup screen shown below.
●Return to Linkage menu
Data resetting method
1. Tap to the item you want to reset and tap
the screen.
*A confirmation message appears.
2. Execute reset by tapping the "Yes".
CAUTION
Never engage the Data reset function
while the engine is starting or the motor
drive wiring is connected.
■ Sudden, abrupt spinning of propellers or rotors
is extremely dangerous.
Model memory setting data reset. (by item)
Model menu setting:
Resets all the functions in the Model menu
except condition select.
All model setting:
Resets all Linkage and Model menu functions
except for frequency, model select, and model type.
Function Name:
A function name is reset.
Telemetry:
Reset the telemetry setting.
[T1-T6 (All condition)]: Resets only the T1-T6 (all
conditions)
[T1-T6(Current and Group condition)]: Resets
only the data of T1-T6 (condition in use and
all the conditions set to group mode)
[Model menu setting]: Resets all the functions
in the model menu, except the condition
selection functions.
[All model setting]: Resets all the functions in
the linkage menu and model menu except
the frequency, model select, and model
type functions.
[Function name]: Resets only the function
name functions.
[Telemetry]: Resets only the teremetry
functions.
CAUTION
Throttle Reverse
■ Only the throttle channel (CH3) initial setting
is REV (reverse). Thoroughly check the Hi and
Low directions of the engine or motor used
and be careful that they do not suddenly run at
full speed.Even after data reset, CH3 is reversed.
＜ Linkage menu ＞
117