Storage And Disposal Precautions - FUTABA T18SZ Instruction Manual

SD Card (Commercial Product) Handling Precautions
WARNING
Never disassemble or modify the SD
Do not unreasonably bend, drop, scratch or
place heavy objects on the SD card.
If smoke or an abnormal odor emanates from the
card, immediately turn off the transmitter power.
CAUTION
Since the SD card is an electronic device, be
careful of static electricity.
■ Static electricity may cause erroneous operation or
trouble.
D o n o t u s e t h e S D c a r d n e a r r a d i o a n d
television sets, audio equipment, motors and
other equipment that generate noise.
■ Doing so may cause erroneous operation.
Do not store the SD card in the following
places:
・ Where the humidity is high
・ Where the temperature difference is severe
・ Where it is very dusty
・ Where the card will be exposed to shock and vibration
・ Near speakers and other magnetic devices

Storage and Disposal Precautions

WARNING
Keep wireless equipment, batteries, aircraft,
etc. away from children.
CAUTION
Do not store wireless devices in the following
places:
・ Where it is extremely hot (40℃ [104F] or higher) or
cold (-10℃ [14F] or lower)
・ Where the equipment will be exposed to direct
sunlight
・ Where the humidity is high
・ Where vibration is prevalent
・ Where it is very dusty
・ Where the device may be exposed to steam and heat
Other Precautions
CAUTION
Do not directly expose plastic parts to fuel, oil,
exhaust gas, etc.
■ If left in such an environment, the plastic may be
attacked and damaged.
■ Since the metal parts of the case may corrode, always
keep them clean.
Join the Academy of Model Aeronautics.
10
＜ Introduction ＞
*Read the instruction manual supplied with the SD card for details.
card. Do not use the SD card where it may be
exposed to water, chemicals, oil, or other fluids.
■ Doing so may cause a fire or electric shock by short
circuiting.
D o n o t i n s e r t f o r e i g n m a t t e r i n t o t h e
transmitter card slot.
■ Doing so will cause trouble.
Do not expose the card to shock and vibration
and do not remove the card from the card slot
while data is being written or read.
■ The data may be damaged or lost.
● Recorded data
T h e d a t a r e c o r d e d o n t h e S D c a r d c a n n o t
be compensated regardless of the contents
o r c a u s e o f t h e t r o u b l e o r o b s t r u c t i o n .
Futaba does not perform data restoration or
recovery work.
When the device will not be used for a long
time, remove the battery from the transmitter
and aircraft and store them in a dry place where
the temperature is between 0 and 30℃ [32F and
86F].
■ Left standing 'as is' may will cause battery deterioration,
liquid leakage, etc.
■ The Academy of Model Aeronautics (AMA) provides
guidelines and liability protection should the need arise.
Always use genuine Futaba products such as
transmitter, receiver, servo, FET amplifier, battery,
etc.
■ Futaba is not responsible for damage sustained by
combination with other than Futaba Genuine Parts. Use
the parts specified in the instruction manual and catalog.