Telemetry:receiver [Ext-Batt] - FUTABA T18SZ Instruction Manual

18-channel digital proportional r/c system
Hide thumbs Also See for T18SZ:
Table of Contents

Advertisement

Telemetry: Receiver [Ext. battery]
The EXT-VOLT screen will display the data from
the EXT-battery output from the R7008SB receiver.
In order to use this function, it is necessary to
connect external voltage connector of the R7008SB
receiver to a CA-RVIN-700 (FUTM5551) or
SBS-01V to the battery you desire to measure the
voltage of the EXT-battery.
● Tap the [Receiver] button in the Telemetry screen
to call the setup screen shown below.
●Return to
Linkage menu
Max. and min. values
s i n c e t h e p o w e r
was turned ON will
display.
↓ The "down" arrow
will indicate that an
alarm will sound when
the voltage drops to
below the setting.
Alarm is chosen from
Buzzer, Voice, and
Inhibit.
The ON/OFF switch
of Speech is chosen.
Alarm set
1. Tap to the ↓Alarm item, and it chooses from
Buzzer, Voice, and Inhibit.
2. When not operating vibrator, it is "Vibrator" to
Inhibit. Type1-3 will be chosen if it is made to
operate.
3. Tap to the Limit [4.0V] item .
4. Ajust the rate by "▼▼" "▼" "▲" "▲▲" button.
Initial value: 4.0V
Adjustment range: 0.0V~100.0V
*When the screen is tapped for one second, the rate is reset
to the initial value.
5. To terminate the input and return to the
original state, push the HOME/EXIT button.
98
< Linkage menu >
Displaying data from the EXT
battery voltage port
*CA-RVIN-700 must be installed in the aircraft.
You will be alerted by an alarm or vibration if
the voltage set by you is exceeded.
*It cannot be used in FASST mode and S-FHSS mode.
*Only receiver voltage and EXT voltage can be used in
FASSTest12CH mode.
*The FASSTest18CH /T-FHSS mode can use all the telemetry
functions.
"Vibrator" type
If the following types are selected, the transmitter
will vibrate during the warning.
Type 1
Type 2
Type 3
Ext. battery
voltage
A setup of the
voltage on which the
alarm operates.

Advertisement

Table of Contents
loading

Table of Contents