Acceleration - FUTABA T18SZ Instruction Manual

Acceleration

This function is used to adjust the pitch and
the throttle rise characteristic at acceleration/
deceleration operation. An acceleration function
which temporarily increases the pitch and throttle
operations at throttle stick acceleration/deceleration
operation can be set.
Example of acceleration function use
●When used at pitch, the acceleration
function is effective when you want to
quicken the response of the fuselage at 3D
flight flip, etc.
When used, high pitch temporarily exceeds
maximum pitch, but immediately returns to
maximum pitch.
● Select [Acceleration] at the model
menu and call the setup screen shown
below.
W h e n u s i n g t h i s
function, Tap to the
[ I N H ] i t e m . ( O N i s
displayed.)
●Return to Model menu
The rate the angle
increases.
Setting method
● Acceleration can be set at both setting
a t a c c e l e r a t i o n ( h i g h ) a n d s e t t i n g a t
deceleration (low).
(The operation point is displayed on a
graph.)
● Acceleration rate setting (Rate)
● The return time after operation (Damping)
can be set.
Condition group/
single mode selection
(Gr. /Sngl)
The return time after operation (Damping)
can be set.
（First return）1 ～ 100（Slow return）
（Acceleration doesn't function as 0.）
＜ Model Menu (Helicopter Functions) ＞
To next page
1/2 : Pitch
2/2 : Throttle
● T h e o p e r a t i o n p o i n t a t a c c e l e r a t i o n
and deceleration can be set. When an
operation point is exceeded, acceleration is
performed.
Note: When using the acceleration function,
since the pitch stroke is large, make your
settings so there is no binding of your linkage.
Operation up to this
range will initiate
acceleration.
Act position
Current position
157