FUTABA T18SZ Instruction Manual page 95

Sensor : Change slot
This procedure changes the slot No. of one
registered sensor.
● Call page 3/3 from the [Sensor] menu.
●Return to
Linkage menu
● Tap the [Change slot] button
in the Sensor screen to call the
setup screen shown below.
Sensor slot change
1. Connect the sensor to the T18SZ through a
shown in the figure above.
2. Tap to the "Change slot" on page 3/3 of the
<Sensor> screen.
3. Tap to the "Read".
4. A sensor details screen appears.
5. The current start slot is displayed. To change
a start slot, a ＋ ― button, tap.（Cannot be
set to a slot that cannot be allocated like the
table of all pages.）
6. Tap to the "Write".
This page is set when using multiple telemetry sensors
of the same type.
T18SZ
*For some transmitters (e.g., T6K), when the start slot of a
sensor is changed, the sensor cannot be used.
WARNING
Do not disconnect or turn transmitter
power OFF while telemetry sensor
data is being saved.
■Sensor save data will be lost, resulting in
malfunction.
＜ Linkage menu ＞
*It is not necessary to carry out
m u l t i p l e c o n n e c t i o n o f t h e
battery like a T18MZ/T14SG.
95