FUTABA T18SZ Instruction Manual page 29

•Stick Tension (J1)
(Mode 1/2)
•Stick Tension (J2)
(Mode 2)
1.5mm hexagonal wrench
Screw is counter-clockwise.
Stick tension minimum
5. At the end of adjustment, re-install the side
cover and rear grips.
•Stick Tension (J4)
(Mode 1/2)
•Stick Tension (J3)
(Mode 1)
Screw is clockwise.
Stick tension maximum
Adjustment of the stick lever
angle
You can make fine adjustments to the angle of
a stick lever either inwards or outwards from the
center stick position.
1.5mm hexagonal wrench
Use the attached 1.5mm hexagonal wrench
(inside stylus) to turn the screw clockwise to adjust
the stick outwards, or counter-clockwise to tilt it
inward.
N o t e : B e c a r e f u l n o t t o t u r n t h e s c r e w t o o f a r
counterclockwise as it could fall out.
29
＜ Before Use ＞