Telemetry:voltage [Ext-Batt] - FUTABA T18SZ Instruction Manual

Telemetry: Voltage [Ext. battery]
In this screen, the EXT battery voltage is
displayed. In order to use this function, it is
necessary to connect External voltage connector of
R7008SB ⇔ SBS-01V ⇔ Battery
SBS-01V measures two batteries. The power
battery connected to two lines is displayed on EXT-
VOLT.
● Tap the [Voltage] button in the Telemetry screen to
call the setup screen shown below.
●Return to
Linkage menu
Max. and min. values
s i n c e t h e p o w e r
was turned ON will
display.
↓ The "down" arrow
will indicate that an
alarm will sound when
the voltage drops to
below the setting.
Alarm is chosen from
Buzzer, Voice, and
Inhibit.
The ON/OFF switch
of Speech is chosen.
Alarm set
1. Tap to the ↓Alarm item, and it chooses from
Buzzer, Voice, and Inhibit.
2. When not operating vibrator, it is "Vibrator" to
Inhibit. Type1-3 will be chosen if it is made to
operate.
3. Tap to the Limit [4.0V] item .
4. Ajust the rate by "▼▼" "▼" "▲" "▲▲" button.
Initial value: 4.0V
Adjustment range: 0.0V~100.0V
*When the screen is tapped for one second, the rate is reset to
the initial value.
5. To terminate the input and return to the
original state, push the HOME/EXIT button.
104
＜ Linkage menu ＞
Displa ying da t a from t he EXT
battery voltage port
*SBS-01V must be installed in the aircraft.
*It cannot be used in FASST mode and S-FHSS mode.
*Only receiver voltage and EXT voltage can be used in
FASSTest12CH mode.
*The FASSTest18CH /T-FHSS mode can use all the telemetry
functions.
"Vibrator" type
If the following types are selected, the transmitter
will vibrate during the warning.
Type 1
Type 2
Type 3
Ext. battery
voltage
A setup of the
voltage on which the
alarm operates.