S.bus/S.bus2 Devicesetting - FUTABA T18SZ Instruction Manual

S.BUS/S.BUS2 device setting
S.BUS/S.BUS2 servos or a telemetry sensor can be connected directly to the T18SZ. Channel setting and
other data can be entered for the S.BUS/S.BUS2 servos or sensors.
S.BUS/S.BUS2
device
(S.BUS/S.BUS2 servo)
(Telemetry sensor)
WARNNG
Do not disconnect or turn transmitter power OFF
while S.BUS servo and telemetry sensor data is
being saved.
■ S.BUS servo and sensor save data will be lost,
resulting in malfunction.
WARNNG
Do not use the S.I/F (S.BUS servo setup) connector
with anything other than high-voltage-capable
S.BUS servos.
■ Transmitter battery voltage (6.6V) is conveyed
directly.
U s i ng a nyt hi n g o th e r t h an h igh- v o l ta g e -
capable servos presents the danger that they
will break.
40
＜ Before Use ＞
T18SZ
1. Connect the S.BUS device you want to set
with as shown in the figure.
2. Turn on the transmitter power.
3. Call the setup screen.
Servo: System Menu → S.BUS servo
Sensor: Linkage Menu → Sensor
4. Perform setting in accordance with each
screen.
5. This sets the channel and other data for each
S.BUS servo, or telemetry device to be used
with the S.BUS device or receiver.
*It is not necessary to carry out multiple
connection of the battery like a T18MZ/
T14SG.
*When you connect to a transmitter many servos
which consume many current, please use
"Another power supply HUB".
And electric power is supplied to a servo with
another power supply.
Hub
S.BUS Servo
●When separate power supply used
When a large number of servos are used or
when high current servos are used, the servos
can be driven by a separate power supply by
using a separate Power Supply 3-way hub.
Green
Hub
（Another power supply）
Used when using a separate
power supply battery.
Hub
（Another power supply）
Switch
Hub
Battery