Flap Setting - FUTABA T18SZ Instruction Manual

Flap setting

The up/down travel of each flap (camber flaps:
FLP1/2, brake flaps: FLP3/4) can be adjusted
independently at each servo according to the wing type.
● The operation reference point of each flap can be
offset
The camber flaps of a 4-flap model can be mixed
with the brake flaps. (Brake FLP to camber FLP)
● An ON/OFF switch can be set.
● Select [Flap setting] at the model menu and
call the setup screen shown below.
●Return to Model menu
Up side/Down side
adjustment
Operation reference
point offset
Up side/Down side
adjustment
Operation reference
point offset
Setting method
● Tap to the flap (FLP) 1~4 up or down item
according to the wing type .
Adjust the travel independently.
● To offset the operation reference point of
each flap, tap to the corresponding offset
item. Use the "▼▼" "▼" "▲" "▲▲" button
offset the reference point.
● When using brake FLP to camber FLP
128
＜ Model menu (Airplane/Glider/Multicopter Functions) ＞
[Corresponding model type]: Airplane/
glider, 2 flaps or more]
Currently selected condition name
Camber flap setting
Operation is performed via the volume
switches, etc., set for each flap control of the
function.
Brake flap to Camber flap setting
FLP 3
(Brake Flap)
FLP 1
(Camber Flap)
Brake flap setting
Mixing
INH ⇔ ON
The ON/OFF switch of
mixing is chosen.
mixing, tap to the [INH] item and tap the
screen. (ON is displayed.)
When setting a switch, tap to the [--] item
of the switch and tap the screen to call the
selection screen, and then select the switch
and set its ON direction. (Always ON at "--"
setting)
(For a description of the switch selection
method, see the description at the back of
this manual.)
FLP 4
(Brake Flap)
FLP 2
(Camber Flap)
Condition group/single
mode selection (Gr. /Sngl)
(For more information, see
the description at the back
of this manual.)
The operational volume
switch is set up by "Function"
*The display screen is an
example. The actual screen
depends on the Model
Type.