FUTABA T18SZ Instruction Manual page 71

Model name change
1. The model data chosen at current model
can be changed. The current model name,
tap.
2. When [Rename] is tapped, a keyboard
appears on the screen.
Current model (green)
is chosen (blue).
3. Enter the model name from this keyboard.
*Up to 15 characters can be input at the model name.
When you are done
renaming, tap Model name.
Completion of rename
WARNING
Never launch the Model Selection function
while the engine is starting or the motor drive
wiring is connected.
■Careless spinning of propellers or rotors is
extremely dangerous.
WARNING
Carefully check that the aircraft to be used and
the model selected match up.
■Using a model which does not match the aircraft
runs the risk of the aircraft flying out of control
and crashing. Perform a careful operations check
prior to flight.
Model copy
1. The model data chosen at current model
can be copied. The current model name,
tap.
Current model (green)
is chosen (blue).
2 . T a p t h e " C o p y " b u t t o n a n d t a p t h e
destination button and select the copy
storage destination. (Internal or SD card)
3. When [Internal]or [SD card] is tapped,
copying is executed.
add new copied model
* If there is no model with the same name in the copy
destination, the name of the copied model is saved. If there
is a model of the same name, a number is added at the end
of the model name and the model is copied. You can change
the name later.
*Indication date : When the model data is copied, a making
day of a current model is copied.
＜ Linkage menu ＞
71