Telemetry:rpm Sensor - FUTABA T18SZ Instruction Manual

Telemetry : rpm sensor
rpm sensor is a screen which displays / sets up
the rotation information from an optional rpm
sensor.
The rotation of the model (engine, motor, etc.)
which is flying can be shown.
If it becomes higher or lower than the setting an
alarm and/or vibration will alert you.
● Tap the [rpm sensor] button in the Telemetry screen
to call the setup screen shown below.
●Return to
Linkage menu
Max. and min. values
s i n c e t h e p o w e r
was turned ON will
display.
↑ An upward arrow
will show that an alarm
will sound when the
rpm rises above the set
value.
↓ A downward arrow
will show that an alarm
will sound when the
rpm falls below the set
value.
Alarm is chosen from
Buzzer, Voice, and
Inhibit.
The ON/OFF switch
of Speech is chosen.
Alarm set : Over （ Under ） rotations
1. Tap to the Alarm item, and it chooses from
Buzzer, Voice, and Inhibit.
2. When not operating vibrator, it is "Vibrator" to
Inhibit. Type1-3 will be chosen if it is made to
operate.
3. Tap to the Limit [xxx rpm] item .
4. Ajust the rate by "▼▼" "▼" "▲" "▲▲" button.
Initial value: ↑ 2,000rpm ↓ 0rpm
Adjustment range: 0rpm~150,000rpm
(↑Limit ≧ ↓Limit)
*When the screen is tapped for one second, the rate is reset
to the initial value.
5. To terminate the input and return to the
original state, push the HOME/EXIT button.
100
＜ Linkage menu ＞
*A rpm sensor must be installed in the aircraft.
*It cannot be used in FASST mode and S-FHSS mode.
*Only receiver voltage and EXT voltage can be used in
FASSTest12CH mode.
*The FASSTest18CH /T-FHSS mode can use all the telemetry
functions.
"Magnet" SBS-01RM →
"Optics" SBS-01RO →
"Brushless motor" SBS-01RB →
If the following types are selected, the transmitter
will vibrate during the warning.
Type 1
Type 2
Type 3
Displaying data from the rpm
rpm
A setup of the rpm
on which the alarm
operates.
Gear ratio 1.00~99.00
Blade 2~10
Pole 2~30
"Vibrator" type