FUTABA T18SZ Instruction Manual page 171

Setting by curve type
When the curve type is selected as described above, adjustment items corresponding to the curve type
appear on the screen. Adjust each curve as described below.
EXP1/EXP2 curve adjustment
(EXP1 curve)
U s i n g t h e E X P 1 c u r v e i s e ff e c t i v e i n
smoothing starting of the ailerons, elevator,
rudder, etc.
(EXP2 curve)
Using the EXP2 curve is effective in engine
rise and other engine control.
The curve left and right rates ([Rate A], [Rate
B]) and EXP curve rate ([EXP A], [EXP B]) can
be adjusted individually. ([EXP] for EXP2)
The curve can also be offset horizontally
([Offset]) in the vertical direction.
[Rate setting]
1. Tap to the [Rate A], [Rate B], [EXP A], or [EXP
B] setting item.
2. Set the rate by "▼▼" "▼" "▲" "▲▲" button.
Initial value: +100.0% (rate)/+0.0% (EXP
rate)
*Initial value differs depending on function.
Adjustment range: -200.0~+200.0% (rate)/-
100.0~+100.0% (EXP rate)
(When the value is tapped, the rate is reset to the initial
value.)
[Offsetting the curve horizontally in the
vertical direction]
1. Tap to the [Offset] setting item.
2. Move the curve in the vertical direction
by "▼▼" "▼" "▲" "▲▲" button.
Initial value: +0.0%
(When the value is tapped, the rate is reset to the initial
value.)
*[Separ.] mode: Normal setting
*[Comb.] mode: Creates a left and right
symmetrical curve.
171
＜ Data ＞